Acoustic-image Series4 Bedienungsanleitung PDF herunterladen

Ten2

Clarus

Coda

Corus

IMPORTANT SAFETY INSTRUCTIONS

FCC COMPLIANCE NOTICE

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with a dry cloth.

7) Do not block any ventilation openings. Install in accordance with

manufacturer’s instructions.

8) Do not install near any heat sources such as radiators, heat registers, stoves

or other apparatus (including amplifiers) that produce heat.

9) Do not defeat the safety purpose of the polarized or grounding-type plug. A

polarized plug has two blades with one wider than the other. A grounding type

plug has two blades and a third grounding prong. The wide blade or the third

prong are provided for your safety. If the provided plug does not fit into your

outlet, consult an electrician for replacement of the obsolete outlet.

10) Protect the power cord from being walked on pinched particularly at plugs,

convenience receptacles, and the point where they exit from the apparatus.

11) Use only attachments/accessories specified by the manufacturer.

12) Use only with the cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus.

13) Unplug this apparatus during lightning storms or when unused for long

periods of time.

14) Refer all servicing to qualified service personnel. Servicing is required

when the apparatus has been damaged in any way, such as power-supply cord

or plug is damaged, liquid has been spilled or objects have fallen into the

apparatus, the apparatus has been exposed to rain or moisture, does not

operate normally or has been dropped.

This device complies with part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

CAUTION: Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment.

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and

receiver.

--Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

--Consult the dealer or an experienced radio/TV technician

for help.

1 2 3 4 5 6 7 8 9 10

Inhaltsverzeichnis

Seite 1

Ten2ClarusCodaCorusIMPORTANT SAFETY INSTRUCTIONSFCC COMPLIANCE NOTICE1) Read these instructions.2) Keep these instructions.3) Heed all warnings.4) Fol

Seite 2 - Welcome to Acoustic Image!

CareWarranty and RepairAcoustic Image combos and cabinets are made from injection moldedpolymer materials. A little care will keep yours looking new f

Seite 3 - Operation--Electronics

WelcomeThe Basics 1Operation--Electronics 3Power 3Preamp 3Inputs 3Controls 45Stereo Operation 69Headphone Output 9Limiter Switch 9Power Amp 10Connecti

Seite 4

mute switch. The two-channel preamp has a switch that allows thesecond channel to be disconnected from the main amp andconnected to a satellite power

Seite 5 - One Channel Control Panel

4optimized to get the best sound from piezo pickups. The XLR input is alow impedance balanced input with sufficient gain to allowmicrophones to be plu

Seite 6 - Two Channel Control Panel

6Direct OutMute SwitchIf you are notgetting any sound out of the amp, check to make sure that themute switch is off.Stereo OperationNote that channel2

Seite 7 - Operation--Speaker Cabinets

8BYPFXFXBYPCH 2SWITCHFXCH 1SWITCHFXCH 2RETURNFXRTNLEVELFXHEADPHONEOUTPUTH/PAMPCH 1RETURNFXRTNLEVELFXTwo Channel Control PanelInputLevel Bass Mid Trebl

Seite 8 - Ten2 and Ten2 EX Rear Panel

10to operate under these conditions with lower distortion or withouthaving the overcurrent circuit kick in. The limiter reduces the peaksignal that is

Seite 9 - Specifications

12the tilt stand at all times in order to aim the high frequency output of thespeaker toward your ear so that you can better hear the amp.An extension

Seite 10 - Warranty and Repair

System (all models)Amp HeadFrequency Response 30 Hz-18 kHz (40-14 kHz ±3 dB)50 Hz- kHz (60-1 kHz ) CorusMax SPL >112 dB at 1 meter,(Corus), >118

Kommentare zu diesen Handbüchern

Keine Kommentare

Acoustic-image Series4 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Empfänger und Verstärker Acoustic-image Series4 herunter. Acoustic Image Series4 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger und Verstärker Acoustic-image Series4